The worst time to learn where your water shut-off is, is while water is coming through the kitchen ceiling. It takes about fifteen minutes on a quiet afternoon to find every valve in the house, label it, and make sure it still turns. Do it once and it pays for itself the first time something lets go.
The main valve
In most Philadelphia rowhomes and twins the main shut-off is in the basement, on the wall facing the street, near the water meter. In a home without a basement it may be in a utility closet, under the kitchen sink, or in a crawl space. Look for a pipe coming in through the foundation wall with the meter on it. There is usually a valve on each side of the meter: the one on the house side is yours to use.
Two kinds of valve are common.
- A ball valve with a lever handle. A quarter turn, so the handle ends up crosswise to the pipe, and the water is off.
- A gate valve with a round wheel. Several turns clockwise. Old gate valves are the ones that seize, and the ones that start weeping at the stem once you finally move them.
If the main does not shut the water off completely, the valve is worn out and should be replaced. That is a plumber's job, and in some cases the Philadelphia Water Department has to be involved on the street side; their site explains what is theirs and what is yours at water.phila.gov.
The valves at each fixture
Shutting the whole house down to fix one faucet is a nuisance, which is what the smaller valves are for.
- Under each sink: two small valves, one for hot and one for cold.
- Behind the toilet: one valve on the supply line near the floor.
- At the washing machine: two valves, often behind the machine on a recessed box. These are worth closing when you go away for a week, because a burst washer hose is one of the most common indoor floods.
- At the water heater: a valve on the cold inlet pipe at the top. Knowing this one lets you isolate the heater without losing cold water to the rest of the house.
- Outside hose bibs: usually an interior valve on the pipe feeding them, which is the one you close in the fall. Our post on preventing frozen pipes covers that routine.
Test them, then label them
Valves that never move are valves that fail when you need them. Once a year, open and close each one fully, then leave it in its normal position. If a valve will not turn by hand, do not force it with a wrench until the pipe flexes; that is how a small problem becomes a flood.
Then label them. A luggage tag or a strip of tape with "MAIN" in marker on it is enough, and it means anyone in the house, including a guest or a neighbor with a key, can find it in a hurry.
What to do in the first minute of a leak
- Shut the nearest valve. If you cannot reach it or it will not hold, go to the main.
- If water is near wiring, outlets or the electrical panel, shut off the power to that area at the panel before you go wading.
- Get the water out and the air moving. The EPA's mold guidance is that damp materials should be dried within 24 to 48 hours; after that you are dealing with mold as well as water.
- Photograph everything before you clean it up, for your insurer.
Calling someone
A seized main, a valve that weeps after you close it, or a leak you cannot isolate are all reasons to get a plumber out rather than wait. Describe the job once and compare estimates from plumbers serving Philadelphia, and check the contractor before anyone starts cutting pipe.
HomeKept is a brand of FalconAI LLC, 331 E Street Rd, Feasterville-Trevose, PA 19053.
HomeKept needs JavaScript. Please enable it and reload the page. ·
HomeKept necesita JavaScript. Actívalo y vuelve a cargar la página. ·
Для работы HomeKept нужен JavaScript. Включите его и обновите страницу.