Portable heaters are how a lot of Philadelphia households get through a cold snap in a back bedroom that the radiators never quite reach. They are also one of the bigger seasonal causes of house fires, and almost all of the risk comes down to three things: what the heater is plugged into, what is near it, and whether anyone is awake.
Plug it straight into the wall
A portable electric heater draws about as much current as a circuit can give. That is why every manufacturer tells you to plug it directly into a wall outlet, and not into an extension cord, a power strip, a surge protector or a multi-outlet adapter. A cord rated for a lamp will warm up under a heater, and a warm cord under a rug or behind a sofa is how a fire starts. If the only outlet in the room is across the room, the answer is a different room or a new outlet, not a longer cord.
While it is running, put a hand on the plug and the faceplate from time to time. A plug that is hot, an outlet that is discolored, or a faceplate that is warm all mean the connection is bad and the circuit should be looked at before the heater is used again.
Give it space, and switch it off
- Keep anything that burns at least three feet away: bedding, curtains, upholstered furniture, laundry, paper, boxes.
- Put it on a hard, level floor, never on a table, a shelf, a rug edge or a carpet it can sink into.
- Keep it out of the bathroom and away from sinks unless it is made for a damp location.
- Switch it off and unplug it when you leave the room and when you go to bed. A heater with a tip-over switch and a thermal cutoff is safer than one without, but neither replaces turning it off.
- Keep children and pets away from it, and never dry clothes on it.
Watch the circuit
Two heaters, or a heater and a microwave, on the same circuit will trip the breaker. That is the breaker doing its job; see why a breaker keeps tripping. What matters is that the fix is to move the load, not to find a bigger breaker.
If your home needs heaters in several rooms every winter, the real problem is usually the heating system or the envelope, and it is cheaper to solve there. A heating tune-up before winter, a look at radiators that are not heating, and work on drafty windows all do more for a cold room than another heater.
Extension cords, in general
- Use them temporarily, not as permanent wiring. A cord that has been in place for a year wants to be an outlet.
- Never run one under a rug, through a doorway, under a door, or stapled to a baseboard.
- Use a cord rated for the job, and an outdoor-rated cord outdoors.
- Do not plug one power strip into another.
- Retire any cord that is cracked, taped, warm in use, or missing its ground pin.
Fuel-burning heaters and carbon monoxide
Kerosene and propane heaters, and any gas appliance, produce carbon monoxide. Never use a gas range or an oven to heat a room, and never run a generator or a grill indoors or in a garage. Working carbon monoxide alarms are the only way to know; our post on smoke and CO detector requirements covers where they are required and how often to replace them.
If outlets in a room are scarce, warm, or old enough that nothing in this post is possible, that is a job for a licensed electrician. Describe it once and compare estimates from electricians serving Philadelphia, after reading how to check a contractor.
HomeKept is a brand of FalconAI LLC, 331 E Street Rd, Feasterville-Trevose, PA 19053.
HomeKept needs JavaScript. Please enable it and reload the page. ·
HomeKept necesita JavaScript. Actívalo y vuelve a cargar la página. ·
Для работы HomeKept нужен JavaScript. Включите его и обновите страницу.