The filter in your furnace or air handler is the cheapest maintenance in the house and the one most often forgotten. A blocked filter starves the system of air, which makes it run longer, heat or cool less well, and in the worst case overheat or freeze. The Department of Energy's advice in its maintaining your air conditioner guidance is the simple version: check it every month during heavy use and change it at least every three months.
What actually sets the interval
The three-month figure is a starting point, not a rule. Shorten it if your home has:
- pets that shed;
- carpet throughout;
- a smoker in the house;
- renovation or sanding work going on;
- a system that runs nearly all the time in a hot summer or a cold snap;
- windows that stay open onto a busy street.
Lengthen it only if the filter still looks clean when you check. The test is not the calendar, it is holding the filter up to a light. If you cannot see light through it, it is done.
Finding and reading it
The filter sits where the return duct meets the furnace or air handler, usually in a slot at the side or the bottom, or behind a return grille in a hallway wall or ceiling. Some homes have both.
The size is printed on the cardboard edge: three numbers, like 16 by 25 by 1. Write it on the inside of a cabinet door, or photograph it, so you are not measuring in a store. Write the date you installed it on the new filter's edge with a marker. The arrow on the frame points in the direction the air flows, which is toward the furnace.
MERV: higher is not automatically better
MERV is the rating for how small a particle the filter catches. A higher number catches more, but it also resists airflow more. Residential systems are designed around a certain amount of resistance, and a very high MERV filter in a system that was not designed for it can reduce airflow enough to cause the problems the filter was meant to prevent. A mid-range pleated filter is the usual compromise for a home without a specific air-quality need. If someone in the house has allergies and you want to go higher, ask your HVAC contractor whether your equipment and ductwork can take it.
Thicker media filters, the four- or five-inch kind in their own cabinet, hold more dust and last longer precisely because they have more surface area. They are a good upgrade when there is room for the cabinet, and they are not a reason to skip checking.
What a dirty filter looks like from the outside
- Rooms that take much longer than they used to to warm up or cool down.
- A system that runs almost continuously.
- Ice on the refrigerant line or the indoor coil in summer.
- A furnace that cycles on and off in short bursts, which can be the high-limit switch reacting to restricted air.
- More dust in the house, not less.
Any of these with a clean filter means it is time for a service call rather than another trip to the hardware store. Our posts on a heating tune-up before winter and on cleaning the air conditioner twice a year cover what that visit includes.
The filter is not the whole story
A filter protects the equipment first and the air second. If your real goal is less dust and better air, the bigger wins are usually sealing duct leaks, venting the bathroom and the dryer outside, controlling humidity, and keeping the return path clear of blocked grilles and closed doors.
If the system is still not keeping up with a clean filter, describe the job once and compare estimates from HVAC pros serving Philadelphia, and read how to check a contractor before you pick one.
HomeKept is a brand of FalconAI LLC, 331 E Street Rd, Feasterville-Trevose, PA 19053.
HomeKept needs JavaScript. Please enable it and reload the page. ·
HomeKept necesita JavaScript. Actívalo y vuelve a cargar la página. ·
Для работы HomeKept нужен JavaScript. Включите его и обновите страницу.